[Close] 

Set Up Technician / Molding Technician

SUMMARY
Set-Up Tech I is responsible for performing the complete mold change process including; mold/supply preparation in advance, mold removal, mold installation, robot and secondary equipment set-up, clean up, and organization. Set-up Tech 1 personnel are responsible for clean-up of machine and surrounding areas, including proper clean up and storage of all mold change materials and supplies. Basic injection mold processing skills required. Must have a complete understanding of the material handling process. Our client will supply on the job training when mold changes and other duties are slow.

ESSENTIAL DUTIES AND RESPONSIBILITIES
Ensures that molds are properly prepped in advance.
Ensures that molds being pulled are properly shut down and prepped for transportation to the mold shop.
Performs all functions of the mold change process. Stays with the mold change until completed even if his/her shift ends, or unless the shift supervisor releases him/her.
Sets up all auxiliary and secondary equipment related to each job change.
Assists as needed in performing start-ups, color changes, pulling packer breaks, etc. as assigned by technician supervisor, shift manager, or area supervisor.
Works together with area supervisors, quality control, packers, assemblers, material handlers, etc. to minimize machine down time and meet or exceed all department production standards.
Understands all procedures associated with the handling of hazardous waste and other trash generated by the department.
Will be required to perform material handling duties when needed.
Performs all nozzle, material manifold cleaning and assembly.
QUALIFICATIONS To perform this job successfully, an individual must be able to perform each essential duty satisfactorily. The requirements listed below are representative of the knowledge, skill, and/or ability required. Must have very good knowledge of the Injection Molding process and the Mold Set-Up process. Individual must also have a good understanding of the molds, materials, injection process, and machinery.
EDUCATION and/or EXPERIENCE
High school diploma or general education degree (GED); or one to three months related experience and/or training; or equivalent combination of education and experience.

Don't Be Fooled

The fraudster will send a check to the victim who has accepted a job. The check can be for multiple reasons such as signing bonus, supplies, etc. The victim will be instructed to deposit the check and use the money for any of these reasons and then instructed to send the remaining funds to the fraudster. The check will bounce and the victim is left responsible.